Welcome To The World Of Rubber Products
           Mfgrs :  Quality rubber  components in all  types of Rubbers, Shapes & Sizes

 

 

SWR RINGS :


Joe Mekeen Elasto Mfgr. (p) Ltd. has developed its own, a wide range of SWR Sealing Rings and lip seals of various Designs and different sizes, which work on a compression seal basis and is uniform in terms of its design around the central axis of  the seal, thus allowing easy insertion of the another pipes and fittings. 

These rings are used for SWR pipes and fittings) and for Drainage pipes, which are durable, long life, low water absorption, 
for high, low and non pressure applications.

Sizes of Rubber Seals for pipes and Fittings.

  • 160 mm diameter RUBBER RING for Pipe & Fittings.

  • 110 mm diameter RUBBER RING for pipe & fittings.

  • 90 mm diameter RUBBER RING for pipe & fittings.

  • 75 mm diameter RUBBER RING for pipe & fittings.

  • 63 mm diameter RUBBER RING for pipe & fittings.
                    DOOR GASKET/ DOOR WASHER.

110 mm door rings for 
DOOR CAP.

75 mm door rings for 
DOOR CAP.

FOR PIPES & FITTINGS
LEAP SEALS

LIP SEAL 125 mm 
for W. C. Connector.

LIP SEAL 110 mm 
for W. C. Connector.

 FOR PIPES & FITTINGS

P – TRAP

P-TRAP SEAL for 
W. C. Connector.

 FOR PIPES & FITTINGS

SPECIFICATIONS AND PROPERTIES OF SWR RINGS.
  

MATERIAL 

NATURAL RUBBER
Hardness (Shore A)

50 ± 5 Shore A.
Tensile strength (Minimum) 

18 Mpa.
Elongation at Break. 420 % Min.
Water Absorption. (Max). 10 %.
AGEING TEST.

 
1. Hardness (Max). - 5 to + 8 ( Shore A)
2. Tensile Strength( Max). ± 20 %
3. Elongation at Break. - 30 t0 10 %

ELASTOMERIC JOINT RINGS 

 

Elastomeric joint rings for pipe work and pipe line (Gas and Hydrocarbon Fluids)

Elastomeric joint rings for pipe work and pipe line (Potable water) 

Elastomeric joint rings for pipe work and pipe line (Water)

Elastomeric joint rings for pipe work and pipe line (Drainage).

Elastomeric joint rings for pipe work and pipe line (Chemicals).

These Rings are used for under ground water pipes and can withstand extreme heat and extreme cold, at high pressure.

Various sizes available are 63mm,90 mm, 110 mm, 140 mm, 160 mm, 225 mm, 280 mm, 315 mm.


SPECIFICATION AND PROPERTIES OF 
ELASTOMERIC RINGS
 

MATERIAL

EPDM
Hardness (Shore A).

50, ± 5 .
Tensile Strength (Min).  11 Mpa.
Elongation at Break. 400 % Min.
Compression set (Max) 12 %
Water absorption (Max). 10 %.
AGEING TEST.
1. Hardness( ShoreA). - 5 to + 8.
2. Tensile strength (Max). ± 20 %.
3. Elongation at Break. - 30 to 10 %.

Designed & Hosted by : MID   Promoted by : GID